3/15/2024 0 Comments Raspberry pi luminator sign![]() I do have the master controller and the Luminator control panel, so a path for custom messaging using these elements would be acceptable in the short term. 10pcs 10Pin Female Pin Header Connector Socket PLUG F Arduino Raspberry Pi b2 3 Best 10pcs memory foam. A middle ground would probably be to remove the 8051, figure out the schematic, and drive the relevant lines with a microcontroller of my own.īefore I give up and go the hard or middle route, does anyone have knowledge of the protocol that is used for these displays? Luminator 510593001 Horizon front sign Display. This particular design is early 90's, with 8051 processors, EEPROMs, and lots of off the shelf logic chips and ULN2xxx series drivers. The display I have already includes a power supply and control board, and it communicates with the master controller via RS-485. EMI/EMC Test Technical Specialist Lead at NTS - National Technical Systems. There are numerous resources on the internet for controlling the flipdot display panels with new circuitry, ignoring the existing circuitry, but I would like to get it working with custom messaging in less time than it would take to design, or even build, a custom hardware solution. Physicist at NTS - National Technical Systems. ![]() ![]() I have an old Luminator flipdot 16x112 pixel bus destination sign I'd like to hack. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |